BASc, Electrical Engineering (co-op), University of Waterloo
First year, started September 2026 · Expected graduation April 2031
- President's Scholarship of Distinction
01Electrium Mobility · Sep 2026
I designed this board in KiCad to drive a 9 V brushed DC motor in both directions at up to 200 mA. The design passed ERC and DRC.
02Personal project · Sep 2026
I breadboarded an Arduino Uno R3 reading an INA219 sensor. A 10-minute test logged 6,000 packets with 0 dropped and 0 checksum errors.
03UWASIC · Oct 2026
My onboarding project at UWASIC. I wrote a mode-0 SPI peripheral in basic Verilog RTL: 16-bit commands set five registers that control the team's 16-output PWM module. All three of my cocotb tests pass.

04ECE 198 Project Studio · Fall 2026
I breadboarded a series RLC band-pass filter and measured its frequency and phase response on an oscilloscope to locate resonance.
05Research Assistant, University of Alberta · Jun–Aug 2026
I wrote Q-learning from scratch in MATLAB and trained an agent for 500 episodes. It learned the shortest path: 8 steps, the minimum possible on this grid.
First year, started September 2026 · Expected graduation April 2031
Waterloo, ON · Sep 2026 – present
Waterloo, ON · Oct 2026 – present
Edmonton, AB · Jun – Aug 2026
Edmonton, AB · Sep 2025 – Jun 2026
Edmonton, AB · May 2025 – Jun 2026